Measuring Tools
Measurement Data Management Convenient data collection tool and quality control software
Digimatic/RS-232C Interface Unit Multiplexer MUX-10F
Specifications • Order No.: 264-002E • Model: MUX-10F • Data input port: 4 channels for Digimatic gages • Output: (RS-232C) • Data output Via RS-232C interface : Data transmission method : Half-duplex Data transmission code : ASCII / JIS Data length : 8 bits Parity check : None Stop bit : 1 Data transmission speed : 300/600/1200/2400/9600/19200 bps • Connector specification:
• Multiplexer MUX-10F is a measurement data transfer device that converts incoming Digimatic output measurement data to RS-232C and outputs it to an external device such as a PC. • Up to four measuring instruments with Digimatic output can be connected.
264-002E MUX-10F
Usage Example Data input using the data button on the Digimatic gage • If the Digimatic gage has a data button, data is sent to the MUX-10F from the gage, converted to RS-232C and sent out. Data input using the load switch • If the Digimatic gage does not have a data button, or when simultaneous measurements are performed, the MUX-10F load switch is used to poll data from the measuring gage (s) selected by the tool selection switch (es), converted to RS-232C , and sent out. • If multiple measuring gages are selected by the tool selection switch, data is input in the order of channels 1 through 4. • Optional foot switch (937179T) is available for quick data entry.
Pin No. Signal
Function
in/out
1 2 3 4 5 6 7 8
CD
out
RD Received data out
Communication data
TD
in
GND Ground
DR
out
CS
out
9 Note : For connection with a PC, use a commercially available RS-232C straight cable.
• Data format
Data input using the external commands • Data from a specified measuring gage connected to MUX-10F can be polled (ch 1- 4) by inputting a command from the PC. Commands (ASCII) Transfer channels 1 (ASCII code31) CR 1 2 (ASCII code32) CR 2 3 (ASCII code33) CR 3 4 (ASCII code34) CR 4 *A (ASCII code41) CR 1, 2, 3, 4 *B (ASCII code42) CR 1, 2, 4 *C (ASCII code43) CR 1, 3, 4 *D (ASCII code44) CR 2, 3, 4 E (ASCII code45) CR 1, 2, 3 F (ASCII code46) CR 1, 2 G (ASCII code47) CR 1, 3 H (ASCII code48) CR 1, 4 I (ASCII code49) CR 2, 3 J (ASCII code50) CR 2, 4 K (ASCII code51) CR 3, 4 * Command will operate the same as previous MUX-10 when 4-channel mode is turned off.
• Power supply: AC adapter (9 V, 500 mA) • External dimensions: 91.4 (W) × 92.5 (D) × 50.4 (H) mm Note : Communication software is not included.
JSR Entech Catalogue 13 jetco@jet.co.th
jet@jet.co.th
Powered by FlippingBook