Magnetie Tools
On/Off switching of upper and bottom face is possible independently. Magnetic V Square Block KVA-2F แม่เหล็กยัดชิ้นงาน ร่องวี
to be used in a wide range application as holding device from marking on round bar to milling. It is used as a holding device for measuring work on iron surface tables.
KVA-2F1A
• Work piece can be held and removed without changing fixed holding position. Working can be done effectively. • On/Off lever is detachable. (length of each opposite side of hexagonal hole is 8mm) • Drip-proof and oil resistance structure
An example of mounting
[mm]
Dimensions Width Height Length
Holding Power
Applicable Diameter
Order No.
392N (40 kgf) or over
Ø8~Ø50 60 105 80
KVA-2F1A
※ The holding power applies to the V-face and ∅ 20 round bar. ※ For accuracy, see the table below.
Magnetic V Square Block KVS แม่เหล็กยัดชิ้นงาน ร่องวี
It is to be used to fix such extra-ordinary shape work pieces under grinding, light milling for making holes and tapping.
• The strong magnetic force works three faces of upper, bottom, edge (or, shorter side) by special structure. • It can be used for inspection work. Standard and special class accuracy are available. • As on/off operation of magnetic force can be easily done by switching lever. • Drip-proof.
KVS-1B
KVS-2B
[mm]
Holding Power Applicable Diameter Dimensions Round Steel VC groove VE groove B a L H
Order No.
700N (70 kgf) 1000N (100 kgf)
100 200
KVS-1B KVS-2B
Ø8~Ø68 Ø8~Ø20 75 50
105
※ The holding power applies to the V-face and ∅ 20 round bar. ※ For accuracy, see the table below. ※ Please take note that attractive force on each face is reduced when a work piece is attracted on more than 2 faces at the same time.
Magnetic V Square Block KMW แม่เหล็กยัดชิ้นงาน ร่องวี
Holding tools for round bar marking and drilling. Holding tools for electric discharge machining and wire cutting. Holding tools for three-dimensional measuring instruments and various measuring systems. • Workpieces can be held on the top face (V face), and rear face. • T-handle ON/OFF switch comes attached, but can be removed. • They are of waterproof and oilproof construction. • One set consists of two blocks. • Super high accuracy finish is also available. Please contact us. • Holding derice for EDM and wire cutting
KMV-125D
KMV-80D
KMV-50D
[mm]
Dimensions B H L a
Applicable Diameter
Order No. KMV- 50D KMV- 80D KMV-125D
Holding Power 150N (15kgf) or over 200N (20kgf) or over 230N (23kgf) or over
Ø50 40 50 70 36
Ø80
80 100 60 100 150 90
50
Ø125
※ The holding power applies to the V-face and ∅ 20 round bar. ※ For accuracy, see the table below.
JSR Entech Catalogue 392
jet@jet.co.th
jetco@jet.co.th
Powered by FlippingBook