Magnetie Tools
Magnetic V Square Block KMV-M แม่เหล็กยัดชิ้นงาน ร่องวี
These blocks are used to hold small diameter round bars on optical measuring equipment. (Non-waterproof type)
• One set consists of two blocks. The attractive faces and other working faces have been machined accurately. The blocks can be turned ON and OFF by 90˚ turning using a screwdriver on the back.
KMV-M025
KMV-M032
[mm]
Dimensions B B1 B2 H L 20 12 1.4 20 20 25 15 2 25 25 32 20 1.6 32 32
Applicable Diameter
Order No. KMV-M020 KMV-M025 KMV-M032
Holding Power 9.8N (1 kgf) 19.6N (2 kgf) 49N (5 kgf)
∅ 15 ∅ 20 ∅ 25
※ The holding power applies to round steel ∅ 10.
■ The dimensional accuracy of KMV is based on Kanetec's in-house standard. When you need higher accuracy. please contact us.
Mangetic Chuck block KT • KTV แม่เหล็กยึดชิ้นงาน
These blocks are used in combination with a magnetic chuck as an auxiliary tool to hold round bars and sheet like workpieces that are difficut to hold on their side faces only by chucking.
KT-4
KT-1
• Since the blocks are not magnetized themselves, they are placed on a magnetic chuck to induce magnetism to hold workpieces. Magnetism can be induced on two faces of top and side or V face and side. • Specially-shaped workpieces can also be held by use of chuck blocks, thus making it possible to utilize your chucks in stock. • One set of two blocks has been finished together. (KT-3 and -4 are available individually.)
KTV-1
An example of usage
[mm]
Dimensions
Pole Pitch
Order No.
B
L
H B1
B2 3.2
70 45
100 72 150 304
41 22
3.2
KT-1 KT-2 KT-3 KT-4
3
125
38
4.5
2 3
60
65
40
3.2
KTV-1
※ KTV-1 Applicable diameter to use : dia. 10~70mm ※ KIn case of additional process, please inquire of us.
Mini V-Adaptor MV แม่เหล็กยึดชิ้นงาน
This product itself is not magnetic, but when it is placed on a V-Holder having the N pole and S pole on separate sides like Model KVA, it induces magnetism to hold small diameter workpieces that can not be physically mounted directly. (See the figure below.) This adapter is recommended for holding workpieces during grinding, drilling and measurement
An example of usage
MV-1
• The attractive faces can be set to any angle between 90 and 180 degrees. • The hinge part acts as a separator to divide magnetic poles.
Order No. MV-1
JSR Entech Catalogue 393 jetco@jet.co.th
jet@jet.co.th
Powered by FlippingBook