Spray Gun
Special - Designed Spray Guns for Automotive Refinishing ปืนพ่นสีสำ �หรับทำ�สีรถยนต์แบบละเอียดพิเศษ
New atomization system By improving transfer efficiency, over mist and paint deviating from the coated articles are reduced, which is achieved by the unique atomization system with small collision angles to the coated articles. Further, by reducing air consumption amount, operation time of the air compressor can be reduced.
Forming uniform coating film in spraying small amount of paint, which is important in repairing vehicles, stabilized paint particles and patterns, even in reducing spraying air amount, spraying pressure and paint spraying amount.
The head is lowered, causing unevenness of the film thickness.
By lightening the spray gun head and moving the gun weight to the rear side, posture of the spray gun in spraying operation can be kept at right angle.
FINER-G10TU • This type is the best suited for repairing small areas of vehicles. • Blurred-coating and removing unevenness are performed quite easily due to low air pressure and low air consumption. • Fine particles of paint enable optimum metallic coating and pearl coating. • This type guns assure the same handling- feeling as that of one's favorite gun owing to the lightweight like supermini type guns. • Less splashing to the surroundings enables to reduce repair areas. • Adjustment of new cars, scratching flaws of the bumpers and dimples can be repaired quite easily.
FINER-S16 • The performance and function equal to the gravity guns are obtained, responding to the expectations of the users attracted to the suction type. • Specifications of low pressure and low air consumption and fine particles assure the wide range of coating from metallic coating and pearl coating to blurred coating and removing unevenness.
FINER-P08 • Air consumption is greatly lowered, and high transfer efficiency is realized. • Paint and compressed air amounts are reduced, and maintenance costs etc. of ambient equipment are reduced overall. • Wight saving giving priority to operationality increases operating efficiency.
FINER-G10TU
FINER-S16 with 7SB paint cup
Spraying pressure
Paint spraying volume mL/min
Maximum effective pattern width mm
Required compressor output kW
Paint feed system
Nozzle bore mm
Spraying distance mm
Air consumption L/min
Pattern shape
Standard paint cup
Order No.
MPa (PSI)
Gravity 1.0 0.2 (29) Suction 1.6 0.25 (36) Pressure 0.8
142 176 185
100 160 155
200 230 200
2GA, 4GD, 4G-TA, 3G-U
FINER-G10TU
200
Tulip 1.5 or more
7SB, 10SB-2, 7SLB
FINER-S16 FINER-P08
P, PH, PA, PDP
• The above values were obtained using two-component urethane paint with a viscosity of 12 seconds and a Meiji model V-1 viscosity cup. • Feed pressure should be 0.08MPa for P type. Note : Spraying pressure in kgf/cm 2 = Mpa x 10.1972
JSR Entech Catalogue 882
jet@jet.co.th
jetco@jet.co.th
Powered by FlippingBook